MAS PAINTS UNISEAL 110
UNISEAL #110 is a two-component epoxy based material produced specifically to seal open pores of concrete, wood, bricks and the like. Seals up to 2 mm. depth to eliminate water seepage especially for vertical surfaces.
Major Uses
As a primer sealer prior to top coating
As a concrete conditioner
Reduces undercutting and peeling
Waterproofing and humidity protection
Advantages
Abrasion and impact resistant
Temperature and chemical resistant
Provides durable sealer
Easy to apply
High Flexible
Excellent adhesion to minimal surface preparation
Characteristics & Physical Properties
Colour – Clear
Volume solids – 42%
Components – Two (2)
Mixing ratio – 1 : 1 By volume
Drying Time
Touch Dry – 45 – 60 min.
Recoating Interval – 5 – 6 hrs.
Fully Cure – 7 days
Coverage – 12 /16 m2/L
Surface Preparation
NEW-STEEL:
New concrete should be cured at least 28 days. Remove all loose debris and other contaminants prior to application of multi-etch solution, rinse with fresh water and let it dry for 24 hrs.
OLD CONCRETE:
Concrete should be dry, free from dust, oil, debris and other contaminants. Remove all existing coat (if any) by scraping, grinding or with paint remover.
Mixing & Application
UNISEAL #110 can be applied by brush, roller and spray. Mix thoroughly 1 part of Resin A and 1 part of Hardener B and let stand for 10 – 15 minutes prior to application. Dilution of 5 – 10 % of Epoxy Thinner #135 is recommended if the consistency of the mixture is higher than the required application viscosity. Use a roller suitable for solvent base to evenly distribute the materials.
Reviews
There are no reviews yet.